T9208
Frequently Asked Questions
  Printer Has The Wrong Identity
  Performing A Hex Dump
  Restoring Factory Defaults In The Printer
  Printing the Current Printer Configurations
  Printing a Cleaning Page
  Printer Firmware Version
  Printing Via External Print Server
  Power Save Mode
 
  Printer Has The Wrong Identity
  The printer gives the wrong identity in it's test page (Status Page) and to the PC when using Plug And Play. This can be corrected by downloading the Printer Identity file to the printer. See Technical Note
 
  Performing A Hex Dump
  These printers are not capable of performing hex dump printing.
 
  Restoring Factory Defaults In The Printer
  This function is only available using the Remote Control Panel. This is a software utility supplied with the printer which runs under Windows and you will find a Default button for resetting the printer.
 
  Printing the Current Printer Configurations
  To print the current printer configurations, follow these instructions.
  • Press and hold the Online button on the top of the printer until the lights start flashing. The printer status page will be printed.
  Printing the Cleaning Page
  To print the cleaning page, follow these instructions.
  • Press and hold the Online button on the top of the printer until the lights stop flashing. The printer will produce a cleaning page which will remove any loose toner from inside your printer that can get onto the paper. (Note: After pressing the Online button, there will be a short delay before the lights start flashing.)
  Printer Firmware Version
  To discover the printer firmware version print the Current Printer Configurations and look for the Software versions in the lower left corner of the status page.
 
  Printing Via External Print Server
  These printers will print from external print servers but you may need to use a power supply for the external print server.
 
  Power Save Mode
  These printers do not have a power switch so the only means of powering them off is at the mains supply outlet where the power cable is plugged in. However, the printer does have a power save mode which will allow the printer to power down the heating element in the fuser when it has not been used for a while. For this power save feature to function, the printer must remain online with the green led lit.