T9312
Mono Laser Printer
Frequently Asked Questions
 
  Printer Has The Wrong Identity
  Printing the Current Printer Configurations
  Printing a Cleaning Page
  Printer Firmware Version
  Printing Via External Print Server
  Paper Specifications
 
  Printer Has The Wrong Identity
  The printer gives the wrong identity in it's test page (Status Page) and to the PC when using Plug And Play. This can be corrected by downloading the Printer Identity file to the printer. See Technical Note
  Performing A Hex Dump
  This printer is not capable of performing hex dump printing unless the Network interface unit is installed. With the Network interface installed, you can use the software utility SyncThru to communicate with the printer and set the emulation to Hex Dump. Resetting to PCL emulation is also achieved using the same utility.
 
  Restoring Factory Defaults In The Printer
  This function is only available using the Remote Control Panel. This is a software utility supplied with the printer which runs under DOS and you will find a Default button for resetting the printer.. 
 
  Printing the Current Printer Configurations
  To print the current printer configurations, follow these instructions.
  • Press and hold the Demo button on the top of the printer until the lights start flashing. If you release the button, the printer will print a demo page. However, if you keep the button pressed until the lights flash faster and then release the button, the printer will print a status page.
  Printing the Cleaning Page
  To print the cleaning page, follow these instructions.
  • Press and hold the Demo button on the top of the printer until the lights stop flashing. The printer will produce a cleaning page which will remove any loose toner from inside your printer that can get onto the paper. (Note: After pressing the Online button, there will be a short delay before the lights start flashing.)
  Printer Firmware Version
  To discover the printer firmware version print the Current Printer Configurations (see above) and look for the Software versions in the lower section of the status page.
 
  Printing Via External Print Server
  These printers will print from external print servers but you will need to use a power supply for the external print server. However, you can only utilise the PCL emulation within the printer. The PCL emulation for the T9312 printer is PCL4
 

Paper Specifications
 
Paper Feed Source Size Weight
Paper Cassette A4, Letter, Legal, Folio, Executive, A5, A6, & B5 60-105g/m2

Media Type - Plain Paper only
Multi Purpose Feeder A4, Letter, Legal, Folio, Executive, A5, & B5 60-160g/m2

Media Types -  Paper, Transparencies, Thick Paper & Envelopes